VAG ODIS Engineering ODIS-E installation guide on Windows 8

Tips for sharing to have ODIS-Engineering (ODIS-E) installed and run on Windows 8 operation system, to use with Bluetooth vas 5054a interface or vxdiag vcx nano 5054 diagnostic tools….. Here you go….

-----Xcar360 Automotive diagnostic tool , diagnostic software  sales@xcar360.com

Officially, Odis Service supported for now only under Windows 7 64bit……….
The latest Odis Engineering 7.1.3 supported from latest Windows 8 or 8.1 but again for to run needs the compatibility mode!!!!!!!

Contents:

1 Note on installing ODIS engineering on Windows 8

2 Creation of the hardware key for license generation

3 Installing the ODIS Engineering application

4 Start the application ODIS Engineering

Note: vas 5054a odis source recommendation:

Xcar360.com is a man of his word to trust in

1 Note on installing ODIS engineering on Windows 8

ODIS Engineering is not released for operation with the operating system Windows 8. This workaround is used only for the commissioning of ODIS Engineering under Windows 8 for test purposes. Please follow the steps below to successfully run Windows 8 on your system.

2 Creation of the hardware key for license generation

• Set the compatibility mode of the “HardwareInfo_de_W7.exe” file to “Windows 7”.
• To do this, right-click on the file and select “Properties”. (See Figure 1)

• Select the “Compatibility” tab.
• Set “Compatibility Mode” to Windows 7 (see Figure 2)

• Confirm the change with “Ok”.

3 Installing the ODIS Engineering application

• After you have received the license, you can start the installation of ODIS Engineering.
• Set the compatibility mode of the setup file to “Windows 7”.
• To do this, right-click on the file and select “Properties”. (See Figure 3)

• Select the “Compatibility” tab.
• Set “Compatibility Mode” to Windows 7 (see Figure 4)

• Confirm the change with “Ok”.

4 Start the application ODIS Engineering

• After installing ODIS Engineering, you must still configure the compatibility mode of “OffboardDiagLauncher.exe”.
• To do this, right-click on the file and select “Properties”. (See Figure 5)

• Select the “Compatibility” tab.
• Set “Compatibility Mode” to Windows 7 (see Figure 6)

• Confirm the change with “Ok”.

Done!

Enjoy and good luck!

Xcar360 Automotive diagnostic tool , diagnostic software

More information

Contact

Steven

Senior Sales Engineer

Xcar360.com

sales@xcar360.com

Skype:uuc050

Whatsapp:8613922818729